Per International Building Code R703.7.2.2 Support by roof construction.
The maximum slope of the roof construction without stops shall be 7:12. Roof construction with slopes greater than 7:12 but not more than 12:12 shall have stops of a minimum 3 inch × 3 inch × ¼ inch (76 mm × 76 mm × 6 mm) steel plate welded to the angle at 24 inches (610 mm) on center along the angle or as approved by the building official.
5 x 3½” x 5/16″ angle with 9/16″ holes and 3 x 3 x 1/4 angle iron stops welded every 24 inches to give support to exterior masonry veneer on sloped roof construction. The use of the 3 x 3 x 1/4 angle instead of the 1/4 x 3 flat bar tabs allows for the lintel to be used on either the left or right side of the roof line.
Available in either galvanized or primed after fabrication.
Custom sizes available upon request.
This picture is not to scale, view Blueprint/Tech Specs for actual size.
Request a quote, or contact us with any questions about our eave lintels.
